|
Post by Miniböttcher on Jul 17, 2006 20:03:22 GMT
hi everyone
i am in stages of rebuilding/ uprating my whole engine and i am replacing the oil gallery plugs with grub screws x4 . because at high oil pressure over time they can blow out. (as from the mini builder dvd from mini films) i going to do something right first time, and not have a bad feeling that it my break or go wrong
so i have been searching the internet for m14 size grub screws but with no sucess
and i need a m14 tap to a can tap my block to screw them in to.
so if anyone know where i can get them from or if you have some. please give me a shout.
thanks dean
|
|
|
Post by MiniHaven on Jul 17, 2006 21:36:22 GMT
dean does the m14 relate to 14 millimeter metric or do you need to do it on old money as the rest of the engine is ? have got a metric tap and die set but will have to see if it goes that size , it belonged to by late grandad so ill come with it if you end up using it , dont usually lend stuff out especially sentimental gear but happy to help if i can.
|
|
|
Post by Simon1275mpi on Jul 18, 2006 3:55:15 GMT
My company uses a lot of metrix grub screws etc, but the largest size in our stock would be M10, I'll get the supplers name for you early next week.
Simon
|
|