Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 29, 2010 10:20:44 GMT
swapped complete hubs over because couldnt undo hub nut, fitted hub to hank no probs but struggling with hub on red mini when trying to do hub swivel nuts the swivels keep spinning even when the full weight of the car is on them!!! tried jacking it and even that dont work, they would screw on a little then start spinning again any ideas anybody
|
|
|
Post by MiniGT5 on Aug 29, 2010 13:24:51 GMT
Sounds like the threads have been stripped
N.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 1, 2010 14:48:36 GMT
you were right the threads were busted halfway down must have been when i was putting the hub back in i stripped them, the nuts went on easy enough just when i tried tightening them up they were getting harder to turn so in order to remove the hub i had to take a hacksaw to them lol so ive got one mini that mobile and another thats going nowhere again
|
|
|
Post by monkeyjim on Sept 3, 2010 13:30:34 GMT
When are you retro fitting the injection system into Hank .
Could be a fun project . ;D
|
|
|
Post by MiniHaven on Sept 22, 2010 20:52:45 GMT
hiya steve new swivels are the order of the day mate when re fitting them weight of car should be enough if not a sharp blow with a hammer onto the arm to seat them usually works .......and an air nut gun on your compressor will deffo do it .
|
|