|
|
Post by Kris James on Jul 8, 2010 15:20:05 GMT
I seem to have lot of air pressure in my cooling system iv resently dont head gasket change but having problem bleeding out system my heater wont get hot either  ?? HELP |
|
|
|
Post by MiniGT5 on Jul 8, 2010 16:08:50 GMT
If I remember correctly you may need to disconnect the feed from the heater tap on the cyl head and back fill the heater matrix from there disconnecting the other end where the heater returns to the main system will also help release air traped in the system.
once it is all primed with water reconnect the hoses and run it up to temperature with the heater on hot.
N.
|
|
|
|
Post by coleman262 on Jul 8, 2010 18:01:38 GMT
have you tried running the engine up with the rad cap off, heater on full/ hot... and seeing if it warms up?
|
|
|
|
Post by Kris James on Jul 8, 2010 18:18:08 GMT
yer were should me (Puller) be is it out for heat or pushed in ... simular looking to my choke cable
|
|
|
|
Post by MiniGT5 on Jul 8, 2010 18:50:58 GMT
I think it is out on the rover cars that had the heater tap in line in a pipe.
might be the other way round on the earlier cars.
N.
|
|
?? HELP
