|
Post by bigtony on Jan 2, 2010 20:50:26 GMT
i started to put new engin it o night but found a problum when my mounts each end were to short the clutch side touches sub fram and holes line up all fine but fan end had 1inch gap and holes dont line up to far <----> apart from each other look at engin sitting to left off engin bay
my miniis a 1987 min mayfair it use to be a auto mini been confeted to a manule 10 years ago so how cn i get pased the big gap is there spacers or am i missing something thx a turner ps the engin i had in there the mont was in right place but holes to far a part and soneone had bodge a bolt in a turner
|
|
|
Post by katentel on Jan 2, 2010 21:53:09 GMT
have you taken the engine mount off of your engine at the rad end as you are putting in a metro?
|
|
|
Post by bigtony on Jan 2, 2010 22:37:59 GMT
yes sused it i got to put spacer down both sides because it a auto subframe it bigger to sarb spcers dose the job thx mate
|
|
|
Post by Stephen on Jan 7, 2010 17:11:59 GMT
it is a tight fit...
|
|