|
|
Post by bigtony on Jul 25, 2009 16:57:49 GMT
ho in need off a rover specal tool 18g1381
i have the engin out and got the first two bits off but now there is a big bolt size 40 i think but need a strang tool to get it off if anyone has one i can borrow i br gratefull thx a turner
|
|
|
|
Post by Miniböttcher on Jul 25, 2009 18:13:32 GMT
if its the flywheel bolt, it an 1.1/2" ( 38mm)socket the same socket used to do ball joint nuts,
if you want to get the flywheel off you will also need a puller
if its easier that a photo of it a post it up then we can see what you are on about
|
|
|
|
Post by MiniGT5 on Jul 26, 2009 2:40:48 GMT
IIRC That part number is for a BL Puller but you can use any generic one that will fit.
N
|
|
|
|
Post by bigtony on Jul 26, 2009 9:33:04 GMT
the big center bolt  |
|
|
|
Post by Miniböttcher on Jul 26, 2009 10:04:04 GMT
yeap its the socket i said about above, you will need to lock the flywheel to stop it spinning, you can use a screwdriver in the teeth and wedge against something or a conrod shell bearing works best.
and a puller to get the flywheel off,
i have both if you want to borrow them but i will need the back soon as i am rebuilding my hubs and need that socket back.
you can also buy both at halfords, pullers are around £20 and handy to have, and the socket you can buy singly.
dean
|
|
|
|
Post by bigtony on Jul 26, 2009 15:18:22 GMT
that would be really god trying to do it on a buget it mo got 50pound to do it all in going to be tight as is so yer if i could borrow would be grate i have it back in few days if u can give me a text or a call on 07812451343 can pick up most times
|
|
|
|
Post by bigtony on Jul 27, 2009 9:54:14 GMT
is it possable to bukel or bend flywheel while i the engin the big one u can c in pic thik it caalled thaty
|
|
|
|
Post by Simon1275mpi on Jul 27, 2009 12:27:21 GMT
Hiya Tony
Very difficult to bend that lot, but not impossible to do some damage if you use the wrong tools. Think that lock washer needs bending back to get that main flywheel bolt off.
I'll be in my workshop just outside Hailsham if you want to pop by and borrow the tools. Or chuck that engine in the car and bring it up.
Looks like an interesting flywheel. You might as well put those three bolts back in off those straps to hold the clutch assembly together.
Si
07974 508 461
|
|
|
|
Post by bigtony on Jul 27, 2009 12:44:36 GMT
thx mate but got it off now just looking how tight to do bolts back up then put it all back together looked like somethink got it there got jamed but it all clear so it going back in hope 4 the best but if i still have no luck i pop over thx si the in drive shaft where gose in to engin dose it need cv gress or is it done from engin oil thx
|
|
|
|
Post by Miniböttcher on Jul 27, 2009 17:51:53 GMT
before you bolt it all back together find out were that bolt that got stuck come from and how it got there?  |
|
